CME1002W
Parts associated with CME1002W
- 02-0836-00 — Catch
- 02-2242-02 — Stand off
- 02-2380-02 — Hinge Bushing
- 02-2521-01 — Water Manifold, long
- 02-2527-01 — Water Distributor Tube
- 02-2606-01 — Drain tube
- 02-2806-01 — Shoulder Screw
- 02-2809-01 — Drain Top
- 02-2878-01 — End cover
- 02-2885-01 — Left side liner
- 02-2887-01 — Right side liner
- 02-2888-01 — Back Liner
- 02-2890-03 — Evaporator Cover
- 02-2895-01 — Water Restrictor
- 02-3094-01 — Hose clamp
- 02-3173-01 — Cover plate Not Shown
- 02-3319-02 — Filter drier
- 02-3396-01 — Insulation for TXV (half) for CME865
- 02-3404-01 — Flange retainer
- 03-0255-04 — Wing nut
- 03-0271-00 — Clip for emblem
- 03-0727-06 — Thumb Screw
- 03-1360-02 — Screw
- 03-1403-27 — Screw
- 03-1404-06 — Screw
- 03-1404-10 — Screw
- 03-1404-12 — Screw
- 03-1405-15 — Screw
- 03-1405-20 — Screw
- 03-1418-41 — Screw
- 03-1423-07 — Speed nut for baffle
- 03-1531-01 — Screw
- 03-1539-09 — E-Clip
- 03-1638-03 — Screw for CME865
- 03-1645-01 — Screw
- 03-1652-02 — Bolt
- 03-1702-01 — Screw
- 03-1702-02 — Washer
- 03-1703-01 — Retaining nut
- 11-0436-21 — Cube size control, includes knob
- 11-0478-01 — Water reg .valve
- 11-0486-21 — Hi pressure control switch 18-8750-27 Compressor*
- 11-0491-21 — Hot gas valve for CME1002 for CME1002
- 11-0493-21 — Hot gas valve for CME865 18-8750-24 Compressor*
- 11-0608-21 — Water reg. valve
- 12-0426-01 — Compressor on off switch
- 12-0739-02 — Contactor
- 12-1879-03 — Relay
- 12-1912-01 — Circuit board
- 12-2107-22 — Timer for
- 12-2107-26 — Timer for
- 12-2285-22 — Transformer
- 12-2300-07 — Hi temp cut out
- 12-2376-21 — Bin level control board
- 12-2402-01 — Wire harness, bin level
- 12-2411-01 — Bin ice level switch 18-1903-33 Potential relay
- 12-2414-01 — ON/OFF/WASH switch
- 12-2419-62 — Water Pump
- 12-2446-26 — Inlet water valve
- 12-2469-02 — Contactor, single phase
- 13-0595-00 — Door Gasket, 6’ req.
- 13-0617-02 — O-ring
- 13-0617-11 — O-Ring
- 13-0617-48 — O-Ring
- 13-0674-02 — Tubing, 1.5' req.
- 13-0674-07 — Drain hose (16.5' needed)
- 13-0796-01 — Reservoir Drain Cap
- 15-0411-00 — Strike
- 15-0711-01 — Emblem for sandalwood
- 15-0808-03 — Emblem, for SS or gray
- 16-0832-02 — Stem cap heater, not used on this model. It may be
- 16-0832-03 — Port/core cap Replacement compressors include a crankcase
- 16-0832-20 — Access valve for CME1002
- 16-0874-01 — Receiver
- 16-0875-01 — Suction line header
- 16-0876-01 — Distributor and tubes
- 16-0877-01 — Hot gas manifold for CME1002
- 16-0878-21 — TXV for
- 16-1022-21 — TXV for
- 18-1901-48 — Start capacitor
- 18-1902-55 — Run capacitor, for all except
- 18-1902-57 — Run capacitor for
- 18-1903-33 — Potential relay
- 18-1903-46 — Potential relay
- 18-2200-27 — Sleeve disconnected or used upon installation.
- 18-2200-28 — Grommet
- 18-8200-25 — Water cooled condenser
- 18-8749-22 — Compressor*
- 18-8749-27 — Compressor*
- 18-8750-22 — Compressor*
- 18-8750-24 — Compressor*
- 18-8750-27 — Compressor*
- 19-0503-04 — Gasket
