CME806

View Parts Breakdown

Looking to buy a new ice machine

to replace this model? Request a Quote →

Parts associated with CME806

02-0179-05 — Clamp
02-0540-00 — Scoop
02-1875-03 — Panel bumper/hole plug
02-2380-02 — Spacer
02-2527-01 — Water distributor
02-2806-01 — Shoulder screw
02-2809-02 — Drain top
02-3108-01 — Drain bottom
02-3196-01 — Hinge
02-3274-02 — Door frame (grey)
02-3319-01 — Dryer
02-3319-02 — Dryer
02-3336-01 — Water distributor tube for
02-3337-01 — Cube deflector
02-3338-01 — Drain tube & fittings 16-1019-01 Inlet water fitting for copper
02-3339-01 — Stand pipe
02-3340-01 — Reservoir cover 12-2784-21 Hi volt harness for D + series
02-3341-01 — Float
02-3360-01 — Reservoir washer
02-3361-01 — Water discharge tube for single evaporator models
02-3383-01 — Float stem
02-3383-02 — Float stem
02-3388-04 — Front pump bracket for 12-2586 type pump
02-3388-05 — Rear pump bracket for 12-2586 type pump
02-3405-01 — Inlet Tee
02-3410-21 — Temp sensor, incl. water temp
02-3443-01 — Water fitting for hose
02-3485-01 — Air filter, air cooled only
02-3610-01 — Stand pipe adjusting nut
02-3657-01 — Cascading shield, used on
02-3659-01 — Top insulation
02-3663-01 — Evaporator cover, use began Feb. 1997. Fits A and B series
02-3663-20 — Evap cover w/ ins for C - H series
02-3794-31 — Trim strip.
02-3796-01 — Insulation for above cover
02-3797-21 — C series Front panel kit, gray plastic, includes trim strip & emblems
02-3822-21 — Top panel, plastic, fits all, original to H series
03-0271-00 — is the speed nut for emblem
03-0727-11 — Thumb screw
03-1403-15 — Screw
03-1404-07 — Screw for drain bottom
03-1404-12 — Sheet metal screw for plastic front panel (for A series)
03-1404-18 — Screw
03-1419-22 — Sheet metal screw for ss front panel
03-1423-06 — Speed nut for panel screws
03-1531-01 — Sheet metal screw
03-1539-09 — E-ring
03-1645-01 — Screw 12-2476-01 Hi volt harness for w/o fan control A-C
03-1691-01 — Nylon screw 12-2678-01 Hi volt harness for
03-1711-01 — Sensor clip
03-1731-02 — is the push nut for trim strip
03-1733-01 — Strike (for C to H series panel, SS or plastic)
03-1733-02 — Catch
03-1735-01 — Screw for trim strip (for C to H series)
05-0586-01 — Drain elbow
11-0501-21 — Hi pressure cut out
11-0539-51 — Float (water level) sensor
11-0540-21 — Bin Control Sensor (set)
11-0608-21 — Water regulating valve 12-2719-23 Hot gas valve coil only
12-2471-01 — Hot gas valve w/coil
12-2471-22 — Hot gas valve w/coil
12-2471-24 — Hot gas valve complete w/coil
12-2476-01 — Hi volt harness for w/o fan control A-C
12-2506-01 — Harness
12-2548-01 — Inlet water valve 12-2786-21 Hi volt harness for D + series
12-2586-21 — CME256-1 (115 volt) pump
12-2586-23 — CME506-6 or
12-2586-26 — CME256-6 or -32 (208-230 volt)
12-2586-27 — CME506-1 (115 volt) pump
12-2618-01 — Hi volt harness, w fan control A series
12-2639-02 — A37231-001 A37217-001 A37217-001
12-2644-21 — Low voltage harness A - C series
12-2678-01 — Hi volt harness for
12-2719-23 — Hot gas valve coil only
12-2733-30 — Hot gas valve repair kit (no body, coil)
12-2782-21 — Low volt harness, D + series
12-2782-23 — Low volt harness, D + series
12-2784-21 — Hi volt harness for D + series
12-2786-21 — Hi volt harness for D + series
12-2838-24 — AutoIQ controller
13-0617-09 — O-ring
13-0617-56 — O-ring
13-0674-02 — Tubing, 9' req., order
13-0840-01 — Rubber plug
13-0898-02 — Tubing grommet
13-0903-01 — Bumper for side panels
13-0906-01 — Plastic inlet water hose, 12-2782-23 Low volt harness, D + series
13-0909-01 — Door gasket - 58' *
15-0792-02 — Emblem for C to H series front panel, (CM3)
15-0808-01 — Emblem for ss panel (Scotsman); 03-0271-00 is the speed nut for emblem
16-0701-07 — Mounting flange
16-0832-02 — Stem cap
16-0832-03 — Port cap
16-0832-21 — Access valve
16-0843-02 — Distributor and tubes
16-0843-03 — Distributor assembly
16-0867-21 — they are interchangeable)
16-0874-01 — Receiver
16-0997-01 — Inlet water fitting for hose
16-1009-22 — TXV
16-1017-21 — TXV (was 16-0867-21, they are interchangeable)
16-1019-01 — Inlet water fitting for copper
16-1020-01 — Water fitting for copper A36460-003 Back panel assy (wc)
16-1063-01 — Hot gas valve strainer (not shown)
16-1063-02 — Hot gas valve strainer (not shown)
16-1071-01 — Check valve
16-1076-21 — TXV (interchangeable with all prior)
16-1095-01 — Restrictor
17-2484-01 — GROUNDED.
17-2485-01 — GROUNDED.
17-2593-01 — GROUNDED.
17-2747-01 — USE COPPER CONDUCTORS ONLY
17-2749-01 — BIN
17-2750-01 — FULL RECIEVER
17-2751-01 — USE COPPER CONDUCTORS ONLY
17-2753-01 — DISCHARGE SENSOR
17-2754-01 — BIN BIN THIS BE
17-2757-01 — USE COPPER CONDUCTORS ONLY
18-1901-03 — not used 18-1901-43
18-1901-15 — not used 18-1901-52 18-1901-48 not used 18-1901-48
18-1901-48 — not used 18-1901-48
18-1901-49 — not used 18-2200-35 18-1901-03 not used 18-1901-43
18-1901-52 — 18-1901-48 not used 18-1901-48
18-1902-17 — not used 18-1902-45 18-1902-45 18-1902-30
18-1902-53 — not used 18-1902-53 18-1902-55 not used 18-1902-55
18-1902-55 — not used 18-1902-55
18-1902-68 — 18-1902-17 not used 18-1902-45 18-1902-45 18-1902-30
18-1903-29 — 18-1903-46 not used 18-1903-33
18-1903-33 — not used 18-1903-29 18-1903-46 not used 18-1903-33
18-1903-44 — not used not used 18-1903-50 not used 18-1903-29
18-1903-46 — not used 18-1903-33
18-1903-50 — not used 18-1903-29
18-2200-35 — 18-1901-03 not used 18-1901-43
18-3306-25 — Condenser, A thru E series
18-5505-01 — Fan motor for
18-5505-11 — Fan motor for
18-5505-12 — Fan motor for
18-6900-21 — Condenser, A - E series
18-6900-25 — Condenser, A - E series 13a 16-0832-03 Port cap
18-8503-01 — Fan blade
18-8739-01 — Condenser
18-8744-01 — Condenser
18-8745-01 — Condenser
18-8829-01 — Fan motor for
18-8829-02 — Fan motor for
18-8835-01 — not used 18-8835-01 18-8835-01 not used 18-8835-01
18-8866-02 — Condenser - E Series & up
18-8871-21 — Condenser, other series
18-8874-21 — Condenser, F series
19-0503-04 — Gasket
19-0599-06 — Insulation for TXV